Intended Use; Personnel Qualifcation - WIKA mensor CPC2000 Betriebsanleitung

2. Safety

2.1 Intended use

The model CPC2000 low-pressure controller is used for testing and calibrating pressure
sensors.
GB
The instrument has been designed and built solely for the intended use described here,
and may only be used accordingly.
The technical specifcations contained in these operating instructions must be observed.
Improper handling or operation of the instrument outside of its technical specifcations
requires the instrument to be taken out of service immediately and inspected by an
authorised WIKA service engineer.
Handle electronic precision measuring instruments with the required care (protect from
humidity, impacts, strong magnetic felds, static electricity and extreme temperatures,
do not insert any objects into the instrument or its openings). Plugs and sockets must be
protected from contamination.
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Before putting it back into operation,
wait for the instrument temperature and the room temperature to equalise.
The manufacturer shall not be liable for claims of any type based on operation contrary to
the intended use.

2.2 Personnel qualifcation

Skilled personnel
Skilled personnel are understood to be personnel who, based on their technical training,
knowledge of measurement and control technology and on their experience and knowl-
edge of country-specifc regulations, current standards and directives, are capable of
carrying out the work described and independently recognising potential hazards.
6
WARNING!
Risk of injury should qualifcation be insufcient!
Improper handling can result in considerable injury and damage to
equipment.
The activities described in these operating instructions may only
■
be carried out by skilled personnel who have the qualifcations
described below.
Keep unqualifed personnel away from hazardous areas.
■
WIKA operating instructions, model CPC2000