Assembly And Commissioning; Installation Requirements - Bosch PLS Benutzerhandbuch

Parking Lot Sensor | PLS
1 General description and intended use
The Parking Lot Sensor PLS with TPS110 EU sensor core is designed for detecting parked vehicles in parking lots.
The Parking Lot Sensor PLS with TPS110 EU sensor core is not designed for use in life-sustaining applications,
safety-critical applications or applications for which a malfunction could lead to bodily harm, death or severe property
damage. Only use the Parking Lot Sensor with components approved by BCDS. This user manual is valid for the
Parking Lot Sensor PLS with TPS110 EU sensor core by BCDS.

2 Assembly and commissioning

2.1 Installation requirements

The Customer must comply with all applicable laws and regulations for the installation and operation of the Product,
and if necessary, obtain necessary approvals. The Customer must take appropriate measures to avoid injury of third
parties, for example, by them tripping over the Product. Therefore, the product should, for instance, not be installed on
the sidewalk.
Before installing the sensors, make sure that the necessary infrastructure is working properly - make sure the
gateways are switched on, that a stable Internet connection has been established, and that there is a backend
connection. The backend, as well as the associated management software, must be functional. Make sure that all of
the required components (see Fig. 1 Parking Lot Sensor PLS with TPS110 EU sensor core), as well as the tools, are
ready.
Figure 1 Parking Lot Sensor PLS with TPS110 EU sensor core
3 | 14
1 Cap
2 Screw
3 Core (sensor TPS110 EU)
4 Base (sensor base)