Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Dometic TEC40D Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für TEC40D:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29

Troubleshooting

11
Troubleshooting
Fault
Cause
The control panel
Starter battery is flat.
does not come
Power cable is disconnected or the
on when the
plug is removed.
on/off switch is
pressed.
Fuse (if present) is triggered.
The starter does
Starter battery is flat.
not work when
The main switch is at "0".
the start button is
pressed.
Circuit board is damaged.
Starter is not receiving any power.
The starter turns
Fuel injector is dirty.
but the genera-
Engine is defective.
tor does not start.
The generator
Too much oil in the engine.
tends to go off.
Load is too high.
Air intake is blocked.
Inverter is damaged.
Fault in the injection pump power
supply.
Fuel injector is dirty.
The generator is
Inverter is damaged.
running but does
not supply any
The electrical connections are not
voltage.
connected properly.
26
Remedy
➤ Charge the starter battery.
➤ Contact an authorised
workshop.
➤ Charge the starter battery.
➤ Set the main switch to "I" or
"1".
➤ Contact an authorised
workshop.
➤ Contact an authorised
workshop.
➤ Drain the oil (see chapter
"Changing the oil" on
page 23).
➤ Reduce the consumers.
➤ Check the air filter (see chap-
ter "Servicing the air filter" on
page 24).
➤ Contact an authorised
workshop.
➤ Contact an authorised
workshop.
➤ Check the electric
connections.
TEC40D
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis