Troubleshooting Information - Dometic TEC 40D Bedienungs- Und Wartungsanleitung

FINDING MALFUNCTIONS
The aim of the following information is to help identify and correct any malfunctions and
problems that might occur during use. Some of these problems may be solved by the user,
while for all the others specific technical knowledge or abilities are required, so that they
must only be carried out by qualified technicians of proven experience in the specific field
of operation.
If the problem or fault found is not included in the irregularities noted in the table, consult
the "Alarm messages" paragraph.
Table 6: Operation failures
Problem
When the starter
button is pressed the
control panel does not
light up
When the starter
button is pressed the
unit does not start
The starter motor
turns, but the unit
does not start

TROUBLESHOOTING INFORMATION

Cause
Main fuse damaged
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
Safety switch in pos. 0
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
The internal control panel parts
have failed
The starter motor does not turn
Fuel level too low
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
Remedy
Replace fuse (See
"Replacement of fuses")
Change the battery
Contact the service
department
Press safety switch in order
to enable the power supply
of the equipment.
Change the battery
Contact the service
department
Contact the service
department
Contact the service
department
Fill up with fuel
Contact the service
department
Contact the service
department
- 41 - Use, maintenance and installation instructions
TEC 40D
GB