Packing - INTERSPIRO Spiroscape Bedienungsanleitung

Pack the Spiroscape as described in the instructions in chapter 6.
11.
NOTE: SPIROSCAPE STORED WITHOUT AIR MIGHT LEAK DURING FILLING, IN THIS CASE FOLLOW THESE INSTRUCTIONS:
1. FILL THE CYLINDER SO THAT IT IS COMPLETELY FULL (200 OR 300 BAR OR 3000 PSI).
2. DISCONNECT THE FILLING ADAPTER
3. TURN THE HAND WHEEL CLOCKWISE UNTIL IT CLICKS THREE TIMES.
6

PACKING

Place the cylinder in the bag and firmly tighten the cylinder strap [ref e, figure 5].
1.
Connect the air hose to the regulator and lock it with the pin [ref b, figure 5].
2.
Position the loop strap with the quick-start ring [ref d, figure 5] outside the bag.
3.
Sparingly apply talcum powder 460 190 130 (or another talcum powder) to the
4.
neck seal.
Pull the zipper about one-third closed.
5.
Fold the hood as shown in [figure 6] and place it in the bag; see [figure 5].
6.
NOTE: MAKE SURE THAT THE HOSE IS PLACED ON TOP OF THE CYLINDER AND NOT IS PINCHED BETWEEN THE CYLINDER
AND THE BAG.
Position the strap with the quick-start ring [ref d, figure 5] on top of the hood,
7.
leaving the loop strap outside the bag.
Fit the quick-start ring [ref c, figure 5] to the cylinder valve. Turn the valve knob
8.
anticlockwise to the stop. Make sure that the knob is resting on the quick-start
ring.
Close the zipper.
9.
NOTE: THE ZIPPER SLIDER MUST GO ALL THE WAY TO THE END POSITION. THIS IS SO THAT THE ZIPPER CAN BE OPENED
WITHOUT USING THE SLIDER, BY PULLING THE LOOP STRAP [REF D, FIGURE 5].
Make sure that the pressure gauge can be read through the window on the bag
10.
(the hood should not be visible).
Position the loop strap as shown [ref d, figure 7]. Pull the anti-tamper seal [ref
11.
a, figure 7] through the small hole in the bag and the small ring [ref f, figure 7].
Secure the anti-tamper seal as shown in [figure 8].
10