Checking For Brake Wear - Sumitomo Cyclo Drive 6000 Betriebsanleitung

6.7 Checking for brake wear

The brake is normally assembled as shown in the picture below.
The following air gaps apply to the FB brakes:
Type of brake
FB-01A
FB-02A
FB-05A
FB-1B, 1D
FB-2B, 2D
FB-3B, 3D
FB-5B
FB-8B
FB-10B
FB-15B
FB-20
FB-30
If the air gap limit is exceeded it can be adjusted as set out in the table below.
Type of brakes
FB-01A
FB-02A
FB-05A
FB-1B, 1D
FB-2B, 2D
FB-3B, 3D
FB-5B, 8B
FB-10B, 15B
FB-20, 30
The air gap must be checked at at least three positions (each offset to 120).
If the adjustment is repeated the thickness of the brake lining must be checked.
Brakes are safety-related components.
Brake liners and friction discs are not sold as separate parts.
Brakes are only available as a complete set.
28
D6000_DEU_ENG_01_2010_2.0_991179
Air gap G (mm)
Nominal dimensions Limit
0.2~0.35 0.5
0.6
0.3~0.4
0.7
0.4~0.5 1.0
0.4~0.5 1.2
0.6~0.7 1.5
Thickness limit
Thickness of brake
lining
one-off adjustment
t
x
o
t
x
o
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
Drive 6000 Operating Manual
Part no
Part name
Teil Nr.
1 Stator packet
2 Spacer
3 Brake lining
4 Assembling bolt
5 Boss
6 Shaft retaining C-ring
7 Cover
8 Fan set bolt
9 Fan (Not provided for FB-01A1 and FB-01A)
10 Leaf spring
11 Brake disk
12 Armature plate
13 Spring
14 Electromagnetic coil
15 Ball bearing
16 Motor shaft
x (mm)
6.0
7.2
8.0
6
7
12
Name des Teils
Statorpaket
Abstimmring
Bremsbelag
Screw
Nabe
Lock washer
Abdeckung
Sicherungsschraube
Lüfter
Blattfeder
Bremsscheibe
Ankerscheibe
Feder
Magnetspule
Kugellager
Motorwelle
Cyclostraße 92
85229 Markt Indersdorf