Brake Motors - Sumitomo Cyclo Drive 6000 Betriebsanleitung

A circuit diagram is located in the terminal box. The motors can be connected to the terminal board depending
on the connection voltage as follows:
The rated voltage range as set out in EN 60 034-1 applies to the specified voltages with a ± 5 % voltage or ± 2 %
frequency deviation.
The following tightening torques apply to the threaded bolts on the terminal board:
Screw thread:

6.6 Brake motors

The brake motors are connected in accordance with the following circuit diagrams:
Standard brake
The brake control voltage is noted on the rating plate.
If the stop position of the application is not reached on starting up, this may not have anything to do with
the brake torque.
26
D6000_DEU_ENG_01_2010_2.0_991179
Permissible tightening torque in Nm
M4
M5
M6
M8
Rapid action brake
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
Drive 6000 Operating Manual
1.2
2.5
4.0
7.5
Cyclostraße 92
85229 Markt Indersdorf