Installing The Motor; Cable Glands; Electrical Connection - Sumitomo Cyclo Drive 6000 Betriebsanleitung

Drive 6000 Operating Manual

6.3 Installing the motor

When connecting motors via brackets or an IEC flange, a suitable IP65 seal must be provided. The customer is
Ex
responsible for fitting this seal.
The ventilation openings in the fan hood must not be blocked.
For sufficient cooling, the distance between the hood and the wall must not fall below the FB measurement. FA is
the minimum distance required to remove the fan hood.
Motor size
FB (mm)
FA (mm)
Motor size
FB (mm)
FA (mm)

6.4 Cable glands

Motors can be fitted with the following cable entry points:
Frame
63-71
80-132S
132M-160
Cable glands must comply at least with the motor protection class specified on the model plate.
Unused cable glands must be closed depending on the type of motor protection. Existing plugs must be tighte-
ned firmly.

6.5 Electrical connection

Please refer to the rating plate and these operating instructions as well as the current catalogue for technical data
and information on the permissible operating conditions. You will find information on special versions on your
order confirmation. If anything is unclear, we urgently recommend you to contact the factory or your sales centre
giving the model description and the serial number.
Motor 0.12 - 4.0 kW
Connect the protective earthing conductor to this terminal.
Cyclostraße 92
85229 Markt Indersdorf Phone +49 (0) 8136 66 0
63-71 80 90 100
20 20 20 20
48 49 52 56
63-71 80 90 100
20 20 20 20
61 93 115 121
Conduit threat
1 x M16 x 1,5 1 x M25 x 1,5
2x M25 x 1,5
2 x M32 x 1,5
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com
Standard motor
112-132S 132M-160M
20 25
60 75
Brake motor
112-132S 132M-160M
25 25
132 170
Frame
180
200-225
250
Motor 5.5 - 55 kW
D6000_DEU_ENG_01_2010_2.0_991179
FA or FB
160L 180M 180L 220
30 30 30 30
130 155 170 230
160L 180M 180L 220
30 30 30 30
220 367 370 445
Conduit threat
2 x M 40 x 1,5
2 x M50 x 1,5
2 x M63 x 1,5
25