Fitting A Connecting Part - Sumitomo PARAMAX 9000 Betriebsanleitung

PARAMAX 9000 Operation Manual

6.1 Fitting a connecting Part

When fitting a connecting part ensure that no impact forces or excessive pressure forces act on the
shaft otherwise the bearing could be damaged.
The connection is made with a shrink fit or with the thread fitted to the end of the shaft (Fig. 8).
Using the Mechanical Transmission Element
The dimensions shown in Fig. 9 (A, B and X) should be within the tolerances specified in Table 11.
Tab. 11
Using the Chain, Sprocket wheel and Pinion
- The tensioned chain must be perpendicular to the PARAMAX DRIVE shaft.
- The sprocket wheel and pinion pitch circle must be more than three times the shaft diameter.
- The sprocket wheel and pinion must be fitted as tightly as possible onto the PARAMAX DRIVE so that the
load contact point is as close as possible to the vertical centre line of the unit (Fig. 10).
Using a V-Belt
- If the belt is under too much tension this can lead to damage to the output shaft and bearings. Find
out the right tension from the belt manufacturer's specifications.
- The parallel deviation of the two belt pulleys must be less than 20´ (Fig. 11).
- When using several V-belts only belt pulleys with the same circumference must be used.
Shaft
Fig. 10
Cyclostraße 92
85229 Markt Indersdorf Phone +49 (0) 8136 66 0
Coupling
Fig. 8
Tolerance for dimension A
Tolerance for dimension B
Dimension X
A
Fig. 9
PARAMAX gearboxes
Coupling
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com
Shaft
Thread
0.05mm
0.05mm
according to the connecting element
manufacturer's specifications
B
X
X
Fig. 11
PX_DEU_ENG_06_2009_999345
51