Identification; Product Description And Type Designation; Product Marking; Preparing The Product For Use - Videotec NXM36 Hi-PoE Bedienungsanleitung

4 Identification

4.1 Product description and type
designation
The NXM36 Hi-PoE housing has been developed
for installations in highly corrosive areas such
as industrial chemical, petrochemical, marine,
naval and offshore platforms. Entirely made from
electropolished and passivated AISI 316L stainless
steel for maximum protection against deterioration.
The IP66/IP67/IP68/IP69 level guarantees complete
protection against bad weather and water immersion.
The NXM36 Hi-PoE housing exploits the PoE and Hi-
PoE technology in an optimal way, using the power
provided by the Ethernet cable as the sole source of
electricity to power the network camera along with
heating/demisting.
NXM36 Hi-PoE can be configured via a dip switch
according to the PoE or Hi-PoE standards depending
to the system requirements.
The accessories of wiper and water pump ensure a
constant cleaning of the front window.
The NXM36 Hi-PoE housing can be installed on
NXPTH Pan & Tilt head, to obtain a complete
positioning system.

4.2 Product marking

See the label attached to the product.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
4
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrench
• Spacers
• Bolts and screws
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.

6 Installation

6.1 How to open the housing

Unscrew the screws (01) on the rear flange (02) using
the hexagonal wrench (03) provided.
02
Fig. 1
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
Fig. 2
01 03
MNVCNXM36HIPOE_1925_EN