6.2 How to install the camera
Assemble the camera on the slide using the
insulating spacer (01) and the 1/4" screw and the
washer (02) provided. If necessary, use the spacers to
position the camera and lens correctly.
Fig. 3
Insert the cables through the cable glands and
electrically connect.
Ensure the cable glands are firmly fastened.
6.3 Connection of the PoE power
supply board
Connect the PoE cable from the Power Injector to the
J1 connector.
Connect the camera to the J2 connector.
Fig. 4
MNVCNXM36HIPOE_1925_EN
J1
J2
7 Configuration
7.1 Power consumption
configuration
Before powering the device, you must set the
maximum power consumption of the housing
operating on dip switch SW1.
Fig. 5
POWER CONSUMPTION CONFIGURATION
SW1
POE
**non tradotto**
Tab. 1
SW1
Maximum power
PoE, class 3 (13W max)
Hi-PoE, class 4 (25W max)
5