Specifications - Makita AN450H Bedienungsanleitung

ENGLISH (Original instructions)
2-1. Pneumatic oil
3-1. Adjuster
4-1. Hook
5-1. Contact element
5-2. Shingle guide
5-3. Shingle
5-4. Projection
6-1. Lever
6-2. Adjust plate
7-1. Magazine cap

SPECIFICATIONS

Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work
such as fixing floor joists or common rafters and framing
work in 2 "x 4" housing.
Noise
The typical A-weighted
according to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
7-2. Latch lever
8-1. Coil support plate
8-2. Graduation
8-3. Arrow
9-1. Feed Claw
10-1. Air fitting
10-2. Air socket
11-1. Trigger
11-2. Contact element
12-1. Trigger
Model
Air pressure
Nail length
Nail capacity
Net weight
noise level determined
) : 84 dB(A)
pA
) : 97 dB(A)
WA
END106-3
Vibration
The vibration total value determined according to
EN792:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE059-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG905-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
12-2. Workpiece
12-3. Contact element
13-1. Trigger
13-2. Change lever
14-1. Trigger
14-2. Change lever
15-1. Small rod
15-2. Ejection port
17-1. Cap
18-1. Drain cock
AN450H
1.28 - 2.26 Mpa (12.8 - 22.6 bar)
19 mm - 45 mm
120 pcs.
5.0 mm
ISO VG32 or equivalent
287 mm X 276 mm X 117 mm
2.3 kg
) : 3.0 m/s
h
2
ENG904-2
2
ENG901-1