Specifications; Important Safety Instructions - Makita GN900 Betriebsanleitung

ENGLISH
1. Safety glasses
2. Face shield
3. Battery cartridge
4. Fuel cover
5. Trigger
6. Indication lamp
7. Pusher button

SPECIFICATIONS

Nail length X Shank diameter
Nail collation angle (degree)
Figure of nail head
Dimensions (L X H X W)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Container under pressure, keep away
from temperatures over 50°C (for ex. sun
radiation) Keep container in a well
ventilated place.
............. Use only outside or well ventilated
rooms. Do not breathe gas.
............. Do not use near flames or sprays on
heated surfaces. In use, may form
flammable/explosive vapour-air mixture.
............. Do not damage, puncture or burn even
after use.
............. Wear safety glasses
............. Keep fingers away from trigger when not
driving fasteners to avoid accidental
firing.
............. Use only in ventilated area to avoid
nausea and unconsciousness. Never use
tool in combustible atmospheres.
The tool exhaust may ignite flammable
materials.
............. Do not use on scaffoldings, ladders.
Explanation of general view
8. Pusher lever
9. Magazine
10. Contact element
11. Hex wrench
12. Button
13. Metering valve
14. Cap
Model
Nail capacity
Net weight
Nail L: 50 mm - 90 mm D: 2.9 mm - 3.3 mm
Intended use
END107-3
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work in
2 "x 4" housing.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
• Use the tool only with the Makita genuine fuel cell.
• Never use the tool in enclosed or poorly ventilated
spaces.
• Always wear safety glasses to protect your eyes from
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only Always wear
safety glasses and face shield to protect your eyes
from dust or nail injury. The safety glasses and the face
shield should conform with the requirements of AS/
NZS 1336.
15. Jet nozzle
16. Screws
17. Hook
18. Filter cover
19. Filter
GN900
40 nails (1strip)
34
Clipped
321 mm X 108 mm X 368 mm
3.2 kg
D.C. 7.2 V
ENE0591
ENB111-2
5