Specifications - Makita AF500HP Betriebsanleitung

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency (times/min.)
5. Locking position
6. Released position
7. Lock lever
8. Trigger
9. Contact element

SPECIFICATIONS

Pneumatic tool oil
Dimensions (L X H X W)
Min. hose diameter
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
...... Wear safety glasses.
................ Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fastening on interior work and
furniture work.
Pneumatic nailer/stapler safety
warnings
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and instructions for
future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
• Do not permit those uninstructed to use the tool.
Explanation of general view
10. Adjuster
11. Too deep
12. Flush
13. Too shallow
14. Slide backward
15. Contact top cover
16. Hole
17. Protrusion
18. Nose adapter
Model
Air pressure
Nail length
Nail capacity
Net weight
• No horseplay. Respect the tool as a working
END106-3
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
the tool operators and by other persons in the
immediate working area.
For Australia and New Zealand only
ENE073-1
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
glasses and the face shield should conform with the
requirements of AS/NZS 1336. (Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
ENB110-4
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate the tool in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust.
Operating the tool can create sparks which may ignite
the dust or fumes.
• Keep children and bystanders away while operating the
tool. Distractions can cause you to lose control.
• Illuminate the work area sufficiently.
19. Place first the contact element
against workpiece.
20. Hook
21. Hex wrench 3
22. Driver guide cover
23. Screw
24. Drain cock
25. Thinner
26. Stove
AF500HP
0.98 - 2.26 MPa (9.8 - 22.6 bar)
15 mm - 50 mm
100 pcs.
ISO VG32 or equivalent
228 mm X 61 mm X 207 mm
5.0 mm or more
1.2 Kg
7