Specifications; Additional Safety Rules For Tool - Makita BPT350 Betriebsanleitung

ENGLISH
1. Red part
2. Button
3. Battery cartridge
4. Trigger
5. Lever
6. Sliding door
7. Bolts
8. Driver guide cover

SPECIFICATIONS

Pin nail magazine capacity
Dimensions (L x W x H)
Rated voltage
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............ Read instruction manual.
Intended use
The tool is intended for pressing pin nails into construction
materials such as timbers.
4
Explanation of general view
9. Lamp
10. Driver guide
11. Pin nails
12. Magazine
13. Lock lever
14. Protrusion
15. Nose adapter
16. Holder
Model
Pin nail size
Net weight
ADDITIONAL SAFETY RULES
END004-1
FOR TOOL
1. Always assume that the tool contains fasteners.
Careless handling of the tacker can result in
unexpected firing of fasteners and personal injury.
2. Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the
ENE054-1
fastener causing an injury.
3. Do not actuate the tool unless the tool is placed
firmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may be
deflected away from your target.
4. Disconnect the tool from the power source when
the fastener jams in the tool. While removing a
jammed fastener, the tacker may be accidentally
activated if it is plugged in.
5. Use caution while removing a jammed fastener.
The mechanism may be under compression and the
fastener may be forcefully discharged while
attempting to free a jammed condition.
6. Do not use this tacker for fastening electrical
cables. It is not designed for electric cable installation
and may damage the insulation of electric cables
thereby causing electric shock or fire hazards.
7. Always wear safety goggles or safety glasses with
side shield, and a full face shield when needed.
8. Always remove the battery cartridge before
loading the pin nails, adjustment, inspection,
maintenance or after operation is over.
9. Make sure no one is nearby before operation.
Never attempt to drive pin nails from both the
inside and outside of wall at the same time. Pin
nails may rip through and/or fly off, presenting a
grave danger.
10. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
11. Check walls, ceilings, floors, roofing and the like
carefully to avoid possible electrical shock, gas
17. Groove
18. Hook
19. Screw
20. Hex wrench
21. Material to be fastened
22. Bolt (B)
23. Bolt (A)
BPT350
0.6 x 18, 25, 30, 35 mm
130 pcs
227 mm x 79 mm x 245 mm
2.0 kg
D.C. 14.4V
ENB104-1