Specifications; Additional Safety Rules For Tool - Makita BPT350 Bedienungsanleitung

ENGLISH
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Trigger
2-2. Lever
3-1. Sliding door
4-1. Lever
5-1. Trigger
6-1. Bolts
6-2. Driver guide cover

SPECIFICATIONS

Pin nail magazine capacity
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for pressing pin nails into
construction materials such as timbers.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 74 dB (A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; BPT350
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014
Directives, 2004/108/EC, 98/37/EC.
000230
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
Explanation of general view
7-1. Lamp
7-2. Lever
8-1. Driver guide
8-2. Pin nails
8-3. Magazine
8-4. Lock lever
9-1. Driver guide cover
9-2. Protrusion
9-3. Nose adapter
9-4. Holder
Model
Pin nail size
Net weight
Rated voltage
2
.
in accordance with Council
CE2006
Director
ENE068-1
8JD, ENGLAND
ADDITIONAL SAFETY RULES
ENG043-1
FOR TOOL
1. Always
fasteners. Careless handling of the tacker can
result in unexpected firing of fasteners and
personal injury.
2. Do not point the tool towards yourself or
anyone nearby.
discharge the fastener causing an injury.
ENH102-6
3. Do not actuate the tool unless the tool is
placed firmly against the workpiece. If the tool
is not in contact with the workpiece, the fastener
may be deflected away from your target.
4. Disconnect the tool from the power source
when the fastener jams in the tool. While
removing a jammed fastener, the tacker may be
accidentally activated if it is plugged in.
5. Use caution while removing a jammed fastener.
The mechanism may be under compression and
the fastener may be forcefully discharged while
attempting to free a jammed condition.
6. Do not use this tacker for fastening electrical
cables. It is not designed for electric cable
installation and may damage the insulation of
electric cables thereby causing electric shock or
fire hazards.
7. Always wear safety goggles or safety glasses
with side shield, and a full face shield when
needed.
3
11-1. Groove
11-2. Hook
11-3. Screw
12-1. Hex wrench
13-1. Trigger
13-2. Material to be fastened
15-1. Bolt (B)
15-2. Driver guide cover
15-3. Bolt (A)
BPT350
0.6 x 18, 25, 30, 35 mm
130 pcs
227 mm x 79 mm x 245 mm
2.0 kg
D.C. 14.4V
assume that the
Unexpected triggering
ENB104-1
tool contains
will