Protecting The Environment - Black+Decker EGBL108 Originalanleitung

ENGLISH
or removing a jammed drill bit, use reverse
(counterclockwise) rotation.
♦ To select forward rotation, push the forward/
reverse slider (2) to the left.
♦ To select reverse rotation, push the forward/
reverse slider to the right.
♦ To lock the tool, set the forward/reverse slider
into the centre position.
Selecting the torque
This tool is fi tted with a collar to set the torque
for various screwdriving and drilling applications.
Large screws and hard workpiece materials
require a higher torque setting than small screws
and soft workpiece materials. For the defi nition of
the symbol refer to the listing below.
♦ For drilling in wood, metal and plastics, set the
torque adjustment collar (4) to the symbol.
♦ For screwdriving, set the collar to the desired
setting. If you do not yet know the appropriate
setting, proceed as follows:
- Set the torque adjustment collar (4) to the
lowest torque setting.
- Tighten the fi rst screw.
- If the clutch ratchets before the desired
result is achieved, increase the collar
setting and continue tightening the screw.
Repeat until you reach the correct setting.
Use this setting for the remaining screws.
Drilling/screwdriving
♦ Select forward or reverse rotation using the
forward/reverse slider (2).
♦ To switch the tool on, press the switch (1). The
tool speed depends on how far you press the
switch.
♦ To switch the tool off, release the switch.
Hints for optimum use
Drilling
♦ Always apply a light pressure in a straight line
with the drill bit.
♦ Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
♦ Use a block of wood to back up workpieces
that may splinter.
♦ Use spade bits when drilling large diameter
holes in wood.
♦ Use HSS drill bits when drilling in metal.
♦ Use masonry bits when drilling in soft
masonry.
♦ Use a lubricant when drilling metals other than
cast iron and brass.
46
♦ Make an indentation using a centre punch at
the centre of the hole to be drilled in order to
improve accuracy.
Screwdriving
♦ Always use the correct type and size of
screwdriver bit.
♦ If screws are diffi cult to tighten, try applying
a small amount of washing liquid or soap as
a lubricant.
♦ Always hold the tool and screwdriver bit in
a straight line with the screw.
Maintenance
Your BLACK+DECKER tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
Your charger does not require any maintenance
apart from regular cleaning.
Warning! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug
the charger before cleaning it.
♦ Regularly clean the ventilation slots in your
tool and charger using a soft brush or dry
cloth.
♦ Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
♦ Regularly open the chuck and tap it to remove
any dust from the interior.

Protecting the environment

Separate collection. This product must
not be disposed of with normal household
waste.
Should you fi nd one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled
materials helps prevent environmental
pollution and reduces the demand for raw
materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.