Troubleshooting - Silvercrest SLTR 70 A1 Bedienungsanleitung Und Sicherheitshinweise

Troubleshooting

If you cannot connect the speaker to a compatible external Bluetooth
playback device, proceed as follows:
Make sure that the Bluetooth
♦
playback device .
♦ Make sure that no 3 .5 mm jack cable
on the speaker . When a device is connected via a 3 .5 mm jack cable
the Bluetooth
♦ Ensure that the speaker is switched on .
♦ If you use several external playback devices, ensure that any previously
made connection is disconnected . There may be a previously paired
playback device still within range .
♦ Make sure that the speaker is no more than 10 metres from the external
playback device and that no obstacles or electronic devices are placed
between them .
The following table helps to identify and rectify further possible faults:
Fault
The device will
not switch on .
No sound .
No sound .
│ GB │ MT
■ 48
®
® function of the speaker is deactivated .
Possible cause
The internal battery
is empty .
The speaker is not
switched on .
The volume is set to
minimum .
The speaker is muted
in AUX mode .
The external play­
back device is muted
in AUX mode .
The 3 .5 mm jack
cable is not
q
correctly connected
in AUX mode .
function is activated on the external
is connected to the AUX input
q
Remedy
Charge the internal battery (see
section Charging the internal
battery)
Press and hold the
for about 2 seconds to switch the
speaker on .
Set the desired volume with the
/ button
also increase the volume on the
external playback device .
Press the button
the speaker .
Unmute the external playback
device .
Ensure that the 3 .5 mm jack
cable is correctly connected to
q
the AUX input
and the external playback device .
SLTR 70 A1 / SLTE 70 A1
®
6
q
button
5
. If necessary,
2
to unmute
4
on the speaker
6
,