Checking The State Of Charge; Charging External Devices - Silvercrest SPB 2.600 C1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SPB 2.600 C1
Alternatively, you can charge the power bank
battery with the USB power adapter of your mobile
device
specifications:
5V

Checking the state of charge

You can also check the state of charge of your power bank
when it is not being charged or discharged. To do this, press
the State of charge / START pushbutton (1) briefly. The LEDs
(2, 3, 4, 5) will indicate the state of charge of the power bank
for approx. 35 seconds.
LED indicator
All LEDs on
Three LEDs on
Two LEDs on
One LED on
All LEDs off
Please note that the LED display gives only an approximate
value of the actual charge level of the Power Bank.

Charging external devices

 To charge an external device with your power bank, use the
supplied USB charging cable (B) to connect the power bank
to the external device. To do so, insert the Micro USB plug of
the USB charging cable (B) into the Micro USB socket of
your external device and then connect the USB plug into the
12 - English
if its output
, min. 1A
meets the
State of charge
75-100%
50 - 74%
25 - 49%
1 - 24%
0%
following