Aqua Clean - JUNO JB084C0 Benutzerinformation

26
the oven cavity. Do not use the oven if the
door gasket is damaged. Contact an
Authorised Service Centre.
To clean the door gasket, refer to the
general information about cleaning.
How to remove: shelf supports
To clean the oven, remove the shelf
supports.
CAUTION! Be careful when
you remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the removed accessories in the
opposite sequence.

Aqua Clean

This cleaning procedure uses humidity to
help remove remaining fat and food
particles from the oven.
1. Put 200 ml of water into the cavity
embossment at the bottom of the
oven.
2. Set the function:
3. Set the temperature to 90 °C.
4. Let the oven operate for 30 minutes.
5. Turn off the oven.
6. When the oven is cold, dry the cavity
with a soft cloth.
2
.
WARNING! Make sure that
the oven is cold before you
touch it. There is a risk of
burns.
Removing and installing door
The oven door has two glass panels. You
can remove the oven door and the internal
glass panel to clean it. Read the whole
"Removing and installing door" instruction
before you remove the glass panels.
The oven door may close if you
try to remove the internal glass
panel before you remove the
oven door.
CAUTION! Do not use the
oven without the internal glass
panel.
1. Fully open the door and find the hinge
to the right side of the door.
2. Use a screwdriver to lift and turn fully
the right side hinge lever.
3. Find the hinge to the left side of the
door.