Installation; Installation Location; Fixing; Installation Surface - Gaggenau Rw 4.4 Gebrauchsanleitung

Installation

Installation location

Install the appliance in a dry, well ventilated room.
The installation location should neither be exposed
to direct sunlight nor near a heat source, e.g. a cooker,
radiator, etc. If installation next to a heat source
is unavoidable, use a suitable insulating plate or observe
the following minimum distances to a heat source:
-
3 cm to an electric cooker.
-
30 cm to an oil or solid fuel cooker.
The floor on which the appliance is to be installed
must be rigid. If required, reinforce the floor.
Observe ambient temperature and ventilation
The climatic class can be found on the rating plate
and indicates the ambient temperatures at which
the appliance can be operated.
Climatic class
SN
N
ST
T
Ventilation
Never cover the ventilation openings in the base panel.
The cooling motor otherwise has to increase the output,
and this increases the electricity consumption.
28
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+18 °C to 38 °C
+18 °C to 43 °C

Fixing

For secure installation, the appliance screwed
to neighbouring kitchen furniture and/or units.
It is very important therefore that all bordering furniture
and/or units are fixed securely to the floor and/or walls.
If making structural changes fix the appliance in place
again corresponding to the the installation instructions.

Installation surface

A load bearing base is necessary because of the heavy
weight of the fully laden appliance.
Refer to the following appliance weight table when
loading fully:
-
Wine storage cabinet 45.7 cm
- Wine storage cabinet 61.0 cm
In case of doubt, consult an architect or structural
engineer.

Installing and connecting the appliance

Caution
!
The appliance should only be installed and
connected by a recognised installation engineer
according to the installation instructions belonging
to the appliance.
After installing the appliance, wait at least ½ hour before
switching on the appliance. During transportation the oil
in the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time,
clean the interior of the appliance (see
appliance ).
"
245 kg
310 kg
Cleaning the