Selection Of The Reference Point; End Piece Reference Point - Parkside PLEM 50 A1 Bedienungs- Und Sicherheitshinweise

Press "Return / Clear" button
Home-screen (see Home-screen part for more detail).
Note: Pressing "Return / Clear" button
measurement mode will stop the measurement.

Selection of the reference point

The rear reference point (base) or the end piece reference point or
the front reference point of the device can be used as the contact
surface for any measurement. The reference point is to be set before
measurement. Otherwise, the measured result differs from actual
value. The default reference point setting is from the rear side of
the device. The reference point can be changed by pressing the
reference button
shown on the top left side corner of the display.

End piece reference point

End piece will be useful while a distance is measured from a
33
corner (diagonal room) or from the place, where it is difficult to
reach. End piece
End piece can be unfolded as shown in the fig D using a sharp
33
tool or finger nail. Once finished using, the End piece
folded-back for future use.
46 GB/IE
repeatedly until the desired reference point
12
is located on the rear side of the device. The
33
multiple times to go back to
8
under continuous
8
has to be
33