Before Use; Fitting/Changing The Sander Plate; Selecting A Sanding Sheet; Fitting The Sanding Sheet - Parkside PMFS 200 C3 Originalbetriebsanleitung

Before use

Fitting/changing the sander plate

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
♦ Use the appropriate sander plate
the corresponding application.
♦ Remove the four screws
4a
hex key .
♦ Remove the pre-fitted sander plate.
NOTE
The orbital sander plate
the appliance in one direction. Please pay at-
tention to the arrow marks on the orbital sander
plate . These must point forwards. With the
delta sander plate
♦ Now fit the required sander plate. Ensure that
the mounting plate B is aligned with the sander
plate. The threaded holes of the mounting plate
B must be aligned with the corresponding holes
on the respective sander plate. Align the rubber
pins A (only on sander plates
with the holes in the appliance (see fig. 1).
A
B
Figure 1
♦ Replace the four screws
♦ Check that the sander plate is fitted securely.
│ GB │ IE
■ 18
using the supplied
can only be fitted to
the tip points forwards.
and
using the hex key

Selecting a sanding sheet

Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet.
♦ Please note that you need to use appropriate
sanding sheets with different grains for working
for
different materials.

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
► Before fitting a new sanding sheet, remove any
dust and dirt from the sander plate
Attaching sanding sheets using Velcro:
♦ You can attach the sanding sheet to the sander
plate
♦ Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
)
Removing sanding sheets fitted using Velcro:
♦ Simply pull the sanding sheet off the sander
plate
Attaching sanding sheets without using
Velcro (see fig. B on the fold-out page, not
supplied):
♦ Open the two clamping levers
♦ Push the sanding sheet under the open clamp-
ing rail at one end and clamp it firmly in
place with the clamping lever.
4a
.
♦ Follow the same procedure at the other end.
using Velcro.
(see fig. A on the fold-out page).
.
PMFS 200 C3
.