Maxi-Cosi MiloFix Bedienungsanleitung Seite 40

EN
under such conditions, to cover the seat of the
car with a piece of material or something
equivalent to prevent the harness fixings, and
in particular the metal parts, from becoming
hot and burning the child.
• After putting your child in the seat, ensure that
the harness straps are properly tight. Also
ensure that the strap is not twisted.
• After putting the child in the car seat, ensure
that the harness is sufficiently taut by pulling
the belt. Ensure also that the belt does not
become twisted.
WARNING:
never combine two ISOFIX anchorage and car seat
belt systems to install your child car seat.
ATTENTION:
in ISOFIX use the fitting clips for lower anchorage
to the vehicle is not sufficient. It is essential to fix
the "Top Tether" to the upper anchorage point
recommended by the car manufacturer.
Fitting the MiloFix seat with additional tethers
using the vehicle's ISOFIX additional anchorage
points.
The ISOFIX anchors have been developed to
obtain a safe and easy fixation of the child safety
systems
inside the car. Not all cars are equipped with
these anchors although they are standard on
more recent models. Consult the attached list of
cars for which
the car seat can be installed correctly (you can
42
( )
also consult additional updates of this list on the
website www.maxi-cosi.com)
• In rear-facing position (GR0+), this product
must not be installed to places equipped with a
frontal air bag. You might be able to deactivate
it (see your car manual).
In this case, if you can deactivate the air bag,
you can use the car seat on the front seat.
• In forward facing position (GR1), the seat must
be placed on the car rear seat or exceptionally
on the front seat in accordance with the legisla-
tion in force in the country of use (In France: in
accordance with the conditions stipulated in
decree n° 91-1321 du 27-12-1991). If you use
the MiloFix on the front seat, it should be
possible to deactivate the airbag of the seat in
question or move the passenger seat back to a
maximum (Please consult your car manual).
• When installing the seat in the rear-facing
position, the belt of the top tether can turn one
quarter turn according to the position of the
anchorage point. This does not impair the
proper operation of the product.
• When installing the car seat, it is necessary to
remove the headrest in order to put the top
tether through correctly.
• Warning: when installing the car seat, spaces
between the base of the car seat and the
vehicle seat are possible depending on the
position of the anchorage points within the
vehicle.
• It is essential that the car seat be replaced after
an accident.
• The user must always check that any luggage