Personal Safety - FLORABEST FKS 2200 F3 Originalbetriebsanleitung

Avoid body contact with
•
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators. There is an in-
creased risk of electric shock if your
body is earthed or grounded.
Do not expose power tools to
•
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.
• If it is necessary to replace the connec-
tion cable, we recommend that this be
performed by the manufacturer or an
authorised representative (e.g. autho-
rised workshop, customer service, etc.).
Do not abuse the cord. Never
•
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
When operating a power tool
•
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
•
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of an
RCD reduces the risk of electric shock.
Connect the appliance to a power
socket with a residual current circuit
breaker of rated residual current no
more than 30 mA.
• Use only approved power cable of
type H05RN-F, which are no more than
75 m in length and intended for use
outdoors. The conductor cross section
of the cord must be at least 2.5 mm
Always fully unroll a cable drum before
use. Check the power cord for damage.

Personal safety

CAUTION: In this way you avoid
accidents and injuries:
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while
you are tired or under the influ-
ence of drugs, alcohol or medi-
cation. A moment of inattention white
operating power tools may result in
serious personal injury.
Wear personal protective equip-
•
ment and always wear safety
glasses. Wearing personal protective
equipment such as nonslip safety boots,
cut protection trousers, a hard hat or ear
protection reduces the risk of injuries.
Prevent unintentional starting.
•
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying
the tool. Carrying power tools with
your finger on the switch or energising
power tools that have the switch on
invites accidents.
Remove any adjusting key or
•
wrench before turning the pow-
er tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
Do not overreach. Keep proper
•
footing and balance at all times.
This enables better control of the pow-
er tool in unexpected situations.
Keep your hair, clothing and
•
gloves away from moving
G B MT
.
2
6 3