Personal Safety - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

frigerators. There is an increased risk
of electric shock if your body is earthed
or grounded.
Do not expose power tools to
•
rain or wet conditions. Water en-
tering a power tool will increase the risk
of electric shock.
• If the supply cord of this power tool is
damaged, it must be replaced by a spe-
cially prepared cord available through
the service organization.
• If it is necessary to replace the connection
cable, we recommend that this be perfor-
med by the manufacturer or an authorised
representative (e.g. authorised workshop,
customer service, etc.).
Do not abuse the cord. Never use
•
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk of
electric shock.
When operating a power tool
•
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
•
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of an
RCD reduces the risk of electric shock.
Connect the appliance to a power sock-
et with a residual current circuit breaker
of rated residual current no more than
30 mA.
• Use only approved power cable of
type H05RN-F, which are no more than
75 m in length and intended for use
outdoors. The conductor cross section
of the cord must be at least 2.5 mm
Always fully unroll a cable drum before
use. Check the power cord for damage.

Personal safety

CAUTION: In this way you avoid ac-
cidents and injuries:
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while
you are tired or under the influ-
ence of drugs, alcohol or medi-
cation. A moment of inattention white
operating power tools may result in seri-
ous personal injury.
Wear personal protective equip-
•
ment and always wear safety
glasses. Wearing personal protective
equipment such as nonslip safety boots,
cut protection trousers, a hard hat or ear
protection reduces the risk of injuries.
Prevent unintentional starting.
•
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying the
tool. Carrying power tools with your
finger on the switch or energising pow-
er tools that have the switch on invites
accidents.
Remove any adjusting key or
•
wrench before turning the pow-
er tool on. A wrench or a key left
attached to a rotating part of the power
tool may result in personal injury.
Do not overreach. Keep proper
•
footing and balance at all times.
This enables better control of the power
tool in unexpected situations.
Keep your hair, clothing and
•
gloves away from moving parts.
Jewellery or long hair can be caught in
. moving parts.
2
Warning! During operation, this elec-
•
tric tool generates an electromagnetic
GB
35