FLORABEST FKS 2200 F3 Originalbetriebsanleitung Seite 64

G B
MT
parts. Jewellery or long hair can be
caught in moving parts.
Warning! During operation, this
•
electric tool generates an electromag-
netic field which, under certain circum-
stances, may impair the functionality of
active or passive medical implants. To
reduce the risk of serious or lethal inju-
ries, we recommend that persons with
medical implants consult their doctor
and the manufacturer of their medical
implant before operating the machine.
Power tool use and care
Do not force the power tool. Use
•
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the
•
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
Disconnect the plug from the
•
power source and/or the bat-
tery pack from the power tool
before making any adjust-
ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
Store idle power tools out of the
•
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
Maintain power tools. Check
•
for misalignment or binding
of moving parts, breakage of
parts and any other condition
6 4
that may affect the power tool's
operation. If damaged, have
the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and
•
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
Use the power tool, accessories
•
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
• For sawing work on a slope, always
stand above the tree trunk. To keep
control at the moment of "sawing
through", reduce the contact pressure
at the end of the cut without loosening
the firm grip on the chainsaw handles.
Ensure that the saw chain does not
come into contact with the ground.
After completing the cut, wait for the
chainsaw to come to a standstill before
removing the chainsaw. Always switch
off the chainsaw motor before moving
from one tree to another.
• Dirt, stones, loose bark, nails, staples
and wire must be removed from the tree.
Service
Have your power tool serviced
•
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
• Follow the maintenance, control and ser-
vice instructions in this manual carefully.
Damaged safety equipment and parts
must be repaired or replaced profes-