Use; Switching The Appliance Off; 2-Speed Gearbox; Grinding - Parkside PAAP 12 A1 Originalbetriebsanleitung

Use

NOTE
► Always switch the hand grinder on before
applying it to the workpiece .
Switching the appliance on:
♦ Press the safety lock-out
symbol to unlock the ON/OFF switch
♦ Press the ON/OFF switch

Switching the appliance off:

♦ Release the ON/OFF switch
♦ Press the safety lock-out
the symbol to lock the ON/OFF switch

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill . Other-
wise the appliance can be damaged .
In first gear (speed selector switch
position: 1)
you can reach a speed of approx . 2800 rpm .
In second gear (speed selector switch
position: 2)
you can reach a speed of approx . 8300 rpm .

Grinding

WARNING!
► Dust from materials such as paints, some types
of wood and metal can be harmful to health .
► Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and any other
people in the vicinity .
► Wear safety goggles and a protective dust
mask!
NOTE
► Make sure that a suitable sandpaper is
correctly fitted on the polishing disc
■ 10 │ GB │ IE │ NI │ CY
on the side with the
.
.
.
on the side with
.
only
in
in
.
♦ Switch the appliance on .
♦ Guide the appliance across the workpiece
parallel to its surface .
♦ Move the unit parallel and evenly over the
surface to be sanded .
♦ Do not press the appliance down . Pressing
down hard does not improve the performance .
♦ When you are satisfied with the result, turn off
the appliance .

Polishing

♦ Add a little polish to the fitted polishing attach-
ment and the workpiece .
,
–
Polishing hood
–
Polishing hood
–
Fake fur attachment
♦ Manually spread the polish over the surface
you want to polish .
NOTE
► Do not apply the polish to the same surface
too often as the particles it contains could
damage the finish .
► Mask any plastic components beforehand as
these could be faded by the polish .
♦ Switch the appliance on .
♦ Guide the appliance across the workpiece
parallel to its surface .
♦ Move the appliance parallel and evenly over
the surface being polished .
♦ Do not press the appliance down . Pressing
down hard does not improve the performance .
♦ When you are satisfied with the result, turn off
the appliance .
ATTENTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken . Use suitable clamps to prevent the
workpiece from slipping .
(orange) for pre-polishing
(black) for final polishing
for high-gloss polishing
PAAP 12 A1