Use And Handling Of The Cordless Electrical Power Tool - Parkside PAAP 12 A1 Originalbetriebsanleitung

5 . Use and handling of the cordless
electrical power tool
a) Charge a rechargeable battery unit using
only the charger recommended by the
manufacturer. Chargers are often designed
for a particular type of rechargeable battery
unit . There is the danger of fire if other types of
rechargeable battery units are used .
b) Only the rechargeable battery units supplied
are to be used with an electrical power tool.
The use of other rechargeable battery units may
lead to the danger of injury or fire .
c) When they are not being used, store recharge-
able battery units away from paperclips, coins,
keys, nails, screws or other small metal objects
that could cause the contacts to be bridged.
Short-circuiting the contacts of a rechargeable
battery unit may result in heat damage or fire .
d) Fluids may leak out of rechargeable battery
units if they are misused. If this happens, avoid
contact with the fluid. If contact occurs, flush
the affected area with water. Seek additional
medical help if any of the fluid gets into your
eyes. Escaping battery fluid may cause skin
irritation or burns .
PAAP 12 A1
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
Protect the rechargeable battery
from heat; for example, from
continuous exposure to sunlight,
fire, water and moisture.
There is a risk of explosion .
6 . Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for hand grinders/polishers
General safety instructions for polishing and
sandpaper sanding
(a) This power tool is to be used as a polisher and
sandpaper sander. Please follow all safety
instructions, instructions, diagrams and data
that you receive with the power tool. Failure
to follow the instructions below may result in
electric shock, fire and/or serious injury .
b) This power tool is not suitable for cutting,
roughing and wire brushing . Using the power
tool for applications for which it is not designed
can lead to hazards and injuries .
c) Do not use any accessories that have not
been specifically provided or recommended
for this power tool by the manufacturer. Just
because you can attach the accessories to your
power tool, does not ensure they are safe to
use .
d) The maximum speed of the accessory tool
used must be at least as high as the maximum
speed specified for the power tool.
Accessories that rotate faster than the maximum
permissible rate can break and throw pieces
into the air .
GB │ IE │ NI │ CY │ 5 ■