Operation - Litecraft battled AT10.x Bedienungsanleitung

Operation

• This device has several DMX­ and Stand­Alone­Modes. In
DMX­mode, multiple devices can be connected and controlled
by a controller. The device accepts the settings of the DMX­
controller, as soon as the corresponding start address is set.
• Slave mode:
Connect the DMX­output of the master device (XLR female)
to the DMX­input of the slave device (XLR male). Set the slave
device to DMX­mode DMX­4CH with the DMX­start address
001 (display shows: DMX­4CH/DMX 001). The slave device
accepts all settings of the master device (such as color macro,
programm, programm speed, color set).
NOTE!
The slave mode is also available in wireless DMX-mode. Please
read chapter: WIRELESS DMX-MODE!
• Display description:
The display shows the different DMX­modes & the DMX­start
address or color macro, programm, programm speed, color
set; the first line shows the mode, the second line the corres­
ponding value. If a DMX­mode is choosen, but actually there
is no DMX­signal present, the display flashes and shows NO
SIGNAL.
• Button description:
Press the MODE button repeatedly to select the mode. Press
the UP or DOWN button to set the DMX­start address or any
of the pre­programmed modes or the speed values. Use the
UP button to increase the value. Use the DOWN button to
decrease it.
NOTE!
If you hold the UP or DOWN button for longer than 3 seconds,
the value changes faster. The device has an automatic storage
for all settings. When you turn the device off and on again, it
works with the previously set values.
19