Litecraft battled AT10.x Bedienungsanleitung Seite 22

USE BY DMX-CABLE AS DMX-TRANSMITTER
One BattLED AT10.x is controlled by cable from a DMX­control­
ler and is sending DMX­data as a transmitter (master) wireless
to all other units. All other BattLED AT10.x are in receiver (slave
mode). All receiver (slave) units can be controlled synchronized
or individually. Also the wireless control of third­party suppliers
(e.g. ROBE) is possible.
• To use BattLED AT10.x in wireless DMX­mode it is impor­
tant to choose the corresponding transmitter/receiver mode
from the lcd first. For using „USE BY DMX-CABLE AS DMX-
TRANSMITTER" one units needs to operate in "Master" and
all others need to operate in "Slave" mode.
• For the transmitter (master) unit following settings need to
be done. Press MODE button until the lcd shows „WiMode".
Change to „Master" with the UP/DOWN buttons for the
transmitter mode. Now the unit needs to be set to one of the
four DMX­modes. Press MODE button until lcd shows „DMX­
1CH", „DMX­2CH", „DMX­3CH", „DMX­4CH" or „DMX­8CH".
Furthermore you need to choose the corresponding DMX­
start adress. Which mode is the right one for you is up to the
range of functions you would like to use, the library and the
channels of the used DMX­controller. Please read chapter
DMX-MODE of this manual to get an idea of which channels
can be controlled in which DMX­mode.
• For the slave/receiver unit following settings need to be done.
Press MODE button until the lcd shows „WiMode". Change
to „Slave" with the UP/DOWN buttons for the receiver mode.
Now the unit needs to be set to one of the four DMX­modes.
Press MODE button until lcd shows „DMX­1CH", „DMX­2CH",
„DMX­3CH", „DMX­4CH" or „DMX­8CH". Furthermore you
need to choose the corresponding DMX­start address if you
want to control slave units individually or the DMX­4CH"
mode and DMX­address „001" for a synchronized control of
all units. Which mode is the right one for you is up to the
range of functions you would like to use, the library and the
channels of the used DMX­controller. Please read chapter
DMX-MODE of this manual to get an idea of which channels
can be controlled in which DMX­mode.
• Up next there is a need for connection (pairing) of the unit
with BattLED AT10.x in transmitter mode (master). Press
CONNECT button on "master" The BattLED AT10.x shortly.
BattLED AT10.x/transmitter searches for all available units and
connects to them. The connection (pairing) is done and safed
until it is released manually.
22
NOTE!
If a unit is not connecting to an external DMX-transmitter it
is already connected to another transmitter. In this case the
connection needs to be released manually. Press and hold CON-
NECT button on corresponding BattLED AT10.x for at least 3
seconds. After this please repeat the procedure for connection
(pairing) whilst pressing CONNECT button on DMX-transmitter
shortly again.
NOTE!
The Wireless-DMX-Operation works also in combination with
BattLED AT5 or BattLED AT10. Please have a look to the original
manual.