Operation - Litecraft PowerBarX.15 Bedienungsanleitung

OPERATION

This device has several DMX- and Stand-Alone-Modes. In DMX-mode, multiple devices can be connected and
•
controlled by a controller. The device accepts the settings of the DMX-controller, as soon as the corresponding
start address is set.
Slave mode:
•
Connect the DMX-output of the master device (XLR female) to the DMX-input of the slave device (XLR male).
Set the slave device to Master/Slave mode Slave (display shows: Master/Slave/<Slave>). The slave device
accepts all settings of the master device (such as programm, programm speed, color/color combination).
Display description:
•
The display shows the different DMX-modes & the DMX-start address or programm, programm speed, etc.; the
first line shows the mode, the second line the corresponding value.
Button description:
•
Press the MENU button to get access to the menu. Press the MENU button or UP/DOWN button repeatedly to
select the relevant topic. Press ENTER button to change the relevant topic; change the relevant topic by
pressing UP/DOWN button to set the DMX-start address or any of the pre-programmed modes or the speed
values. Use the UP button to increase the value. Use the DOWN button to decrease it. Press ENTER button
again to save your settings and get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the previously set values