Electrical Connection
• Connection to the mains is only allowed by skilled persons.
• Before connecting the fixture to the mains, assure that the
specifications are corresponding.
• Electrical grounding has to be used in the whole installation!
ATTENTION!
Installation has to be approved by an authorized person before
first operation!
Cleaning and Maintenance
• Installer has to take care of all safety and machinery installati
ons are approved by skilled persons at least once a year.
• Installer has to take care of all safety and machinery installa
tions are approved by authorized persons at least every four
years during the acceptance inspection. Following points need
to receive special attention:
• All screws used for mounting the fixture or parts of it
need to be proof and must not show corrosion.
• Housing, suspension device and installation site (ceiling,
suspension, truss) must not show deformation.
• All power cords must not show any damage, aging (for
example porous wires) or sediments. Other, to the loca
tion related and usage aligned regulations will be obser
ved by the skilled person and safety defects will be fixed.
ATTENTION!
Make sure that the fixture is disconnected from mains during
all maintenance! It is important to unplug mains connector!
• The fixture must be regularly cleaned from dirt and dust. Only
use a wetted, lintfree cloth for cleaning the fixture. Never
use alcohol or any kind of solvent for cleaning.
• Inside the fixture there are no parts which need maintenance.
Maintenance & service must be done by authorized dealers
only.
• Only use original spare parts!
Advice!
If you have further questions, your local dealer will be happy to
help you.
22
Operation
• This device has several DMX and StandAloneModes. In
DMXmode, multiple devices can be connected and controlled
by a controller. The device accepts the settings of the DMX
controller, as soon as the corresponding start address is set.
• Slave mode:
Connect the DMXoutput of the master device (XLR female)
to the DMXinput of the slave device (XLR male). Set the slave
device to Master/Slave Mode Slave (display shows: Master/
Slave/<Slave>). The slave device accepts all settings of the
master device (such as programm, programm speed, bright
ness, strobe rate).
• Display description:
The display shows the different DMXmodes & the DMXstart
address or programm, programm speed, brightness, strobe
rate; the first line shows the mode, the second line the corres
ponding value.
• Button description: Press the MENU button to get access
to the menu. Press the MENU button or UP/DOWN button
repeatedly to select the mode. Press ENTER button to change
the relevant topic; change the relevant topic by pressing UP/
DOWN button to set the DMXstart address or any of the pre
programmed modes or the speed values. Use the UP button
to increase the value. Use the DOWN button to decrease it.
Press ENTER button again to save your settings and get access
to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value chan-
ges faster. The device has an automatic storage for all settings.
When you turn the device off and on again, it works with the
previously set values