Operation - Litecraft WashX.432 sw Bedienungsanleitung

OPERATION

This device has several DMX and stand alone modes. In DMX mode, multiple devices can be connected and controlled
by a controller. The device accepts the settings of the DMX controller, as soon as the corresponding start address is set.

Slave mode:
Connect the DMX output of the master device (XLR female) to the DMX input of the slave device (XLR male).
Set the slave device to mode slave (display shows: <SLAVE>). The slave device accepts all settings of the
master device (such as SW Macro).

Display description:
The display shows the different DMX-modes & the DMX-start address and dimmer and sw macro. The first line
shows the mode, the second line the corresponding value.

Button description:
Press the MENU button to get access to the menu. Press the UP/DOWN button to select the relevant topic.
Press ENTER button to change the relevant topic. Change the relevant topic by pressing UP/DOWN button to
set the DMX start address or any of the pre-programmed modes or the speed values. Use the UP button to
increase the value. Use the DOWN button to decrease it. Press ENTER button again to save your settings and
get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the previously set values. If the unit is not operated for
about 30 seconds, the buttons are locked. Unlock these by pushing one of the backside buttons for about three seconds.

The unit is additionally equipped with two jogwheels. The use of these jogwheels is possible as long as there is
no DMX-signal present on the DMX-input. Press the required jogwheel shortly and set brightness or sw macro
to the required value. Press and hold the required jogwheel for at least one second until display shows up OK!
And values are stored permanently. When you turn the device off and on again, it works with the previously set
values.