Operation Ir-Remote - Litecraft CubeX.4 Bedienungsanleitung

Operation
• This device has several DMX- and Stand-Alone-Modes. In DMX-
mode, multiple devices can be connected and controlled by a
controller. The device accepts the settings of the DMX-control-
ler, as soon as the corresponding start address is set.
• Slave mode:
Connect the DMX-output of the master device (XLR female)
to the DMX-input of the slave device (XLR male). Set the slave
device to mode Slave (display shows: <SLA>). The slave device
accepts all settings of the master device (such as programm,
programm speed, color/color combination).
• Display description:
The display shows the different DMX-modes & the DMX-start
address or programm, programm speed, etc.; the first line
shows the mode, the second line the corresponding value.
• Button description:
Press the MENU button to get access to the menu. Press the
UP/DOWN button repeatedly to select the mode. Press ENTER
button to change the relevant topic; change the relevant topic
by pressing UP/DOWN button to set the DMX-start address or
any of the pre-programmed modes or the speed values. Use
the UP button to increase the value. Use the DOWN button to
decrease it. Press ENTER button again to save your settings and
get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value chan-
ges faster. The device has an automatic storage for all settings.
When you turn the device off and on again, it works with the
previously set values
20

Operation IR-Remote

• The unit is additionally equipped with an infrared remote
control. The use of this infrared remote control is possible in
every mode. Point the infrared remote control in direction of
the infrared receiver on top of the fixture. Choose a color or a
program by use of the infrared remote control.