Operation - Litecraft OutLED WT20.swa Bedienungsanleitung

OPERATION


This device has several DMX- and Stand-Alone-Modes. In DMX-mode, multiple devices can be connected and
controlled by a controller. The device accepts the settings of the DMX-controller, as soon as the corresponding
start address is set.

Slave mode:
Connect the DMX-output of the master device (XLR female) to the DMX-input of the slave device (XLR male).
Set the slave device to mode DMX-3CH with the DMX-start address 001 (display shows: DMX-3CH/001). The
slave device accepts all settings of the master device (such as white macro, programm, programm speed, white
tone).

Display description:
The display shows the different DMX-modes & the DMX-start address or white macro, programm, programm
speed, white tone; the first line shows the mode, the second line the corresponding value.

Button description:
Press the UP/DOWN button repeatedly to select the relevant topic. Change the relevant topic by pressing
UP/DOWN button to set the DMX-start address or any of the pre-programmed modes or the speed values. Use
the UP button to increase the value. Use the DOWN button to decrease it.
NOTE!
If you hold the UP or DOWN button for longer, the value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the previously set values.
WARNING!
This fixture is using a temperature-sensor used to protect internal electronic and LEDs.

If the display shows "COLD" the ambient temperature is too low. (-20° C). Please wait until display comes back
to its normal state! (mode and value display)

If the display shows "HOT OFF" or "HOT LOW" the internal temperature reaches a too high level. You can
choose between two functions in the menu called "SAFETY". The function "HOT OFF" switches off LEDs if the
internal temperature reaches a too high level. The function "HOT LOW" reduces the LED driving about 25% if
the internal temperature reaches a too high level. As soon as the temperature reaches the normal level, the unit
comes back to its normal state! (mode and value display).

If the display shows "HEAT OFF" the internal temperature reaches a too high level. The LEDs will be switched
off for safety reasons. Please wait until display comes back to its normal state (mode and value display).