Electrical Connection; Cleaning And Maintenance; Operation - Litecraft CPiX.4 Bedienungsanleitung

Electrical Connection

• Connection to the mains is only allowed by skilled persons.
• Before connecting the fixture to the mains, assure that the
specifications are corresponding.
• Electrical grounding has to be used in the whole
installation!
ATTENTION!
Installation has to be approved by an authorized person before
first operation!

Cleaning and Maintenance

• Installer has to take care of all safety and machinery
installations are approved by skilled persons at least once
a year.
• Installer has to take care of all safety and machinery
installations are approved by authorized persons at least
every four years during the acceptance inspection.
Following points need to receive special attention:
• All screws used for mounting the fixture or parts of it
need to be proof and must not show corrosion.
• Housing, suspension device and installation site
(ceiling, suspension, truss) must not show deformation.
• All power cords must not show any damage, aging
(for example porous wires) or sediments. Other, to the
location related and usage aligned regulations will be
observed by the skilled person and safety defects will
be fixed.
ATTENTION!
Make sure that the fixture is disconnected from mains during
all maintenance! It is important to unplug mains connector!
• The fixture must be regularly cleaned from dirt and dust.
Only use a wetted, lint­free cloth for cleaning the fixture.
Never use alcohol or any kind of solvent for cleaning.
• Inside the fixture there are no parts which need main­
tenance. Maintenance & service must be done by auth­
orized dealers only.
• Only use original spare parts!
ADVICE!
If you have further questions, your local dealer will be happy to
help you.
20

Operation

• This device has several DMX­ and Stand­Alone­Modes. In
DMX­mode, multiple devices can be connected and con­
trolled by a controller. The device accepts the settings of
the DMX­controller, as soon as the corresponding start
address is set.
• Slave mode:
Connect the DMX­output of the master device (XLR female)
to the DMX­input of the slave device (XLR male). Set the
slave device to Master/Slave mode Slave (display shows:
Master/Slave/<Slave>). The slave device accepts all settings
of the master device (such as programm, programm speed,
color/color combination).
• Display description:
The display shows the different DMX­modes & the DMX­
start address or programm, programm speed, color/color
combination; the first line shows the mode, the second line
the corresponding value.
• Button description: Press the MENU button to get access
to the menu. Press the MENU button or UP/DOWN button
repeatedly to select the mode. Press ENTER button to
change the relevant topic; change the relevant topic by
pressing UP/DOWN button to set the DMX­start address
or any of the pre­programmed modes or the speed values.
Use the UP button to increase the value. Use the DOWN
button to decrease it. Press ENTER button again to save
your settings and get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value chan-
ges faster. The device has an automatic storage for all settings.
When you turn the device off and on again, it works with the
previously set values.