Operation - Litecraft PAR 64 AT10 Bedienungsanleitung

OPERATION

• This device has several DMX- and Stand-Alone-Modes. In DMX-mode,
multiple devices can be connected and controlled by a controller. The
device accepts the settings of the DMX-controller, as soon as the
corresponding start address is set.
• Slave mode:
Connect the DMX-output of the master device (XLR female) to the
DMX-input of the slave device (XLR male). Set the slave device to
DMX-mode DMX-4CH with the DMX-start address 001 (display shows:
DMX-4CH/DMX 001). The slave device accepts all settings of the
master device (such as color macro, programm, programm speed,
color set).
• Display description:
The display shows the different DMX-modes & the DMX-start address
or color macro, programm, programm speed, color set; the first line
shows the mode, the second line the corresponding value. If a DMX-
mode is choosen, but actually there is no DMX-signal present, the
display flashes and shows NO SIGNAL.
• Button description:
Press the MODE button repeatedly to select the mode. Press the UP or
DOWN button to set the DMX-start address or any of the pre-
programmed modes or the speed values. Use the UP button to
increase the value. Use the DOWN button to decrease it.
NOTE!
If you hold the UP or DOWN button for longer than 3 seconds, the
value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the
previously set values.
III