Operation - Litecraft ZX. 6 Bedienungsanleitung

Operation

• This device has several DMX- and Stand-Alone-Modes. In DMX-mode, multiple devices can be connected and
controlled by a controller. The device accepts the settings of the DMX-controller, as soon as the corresponding start
address is set.
• Slave mode:
Connect the DMX-output of the master device (XLR female) to the DMX-input of the slave device (XLR male). Set the
slave device to M&S Mode Slave (display shows: M&S Mode/<Slave>). The slave device accepts all settings of the
master device (such as programm, programm speed, brightness, strobe rate).
• Display description:
The display shows the different DMX-modes & the DMX-start address or programm, programm speed, brightness,
strobe rate; the fi rst line shows the mode, the second line the corresponding value.
• Button description: Press the MENU button to get access to the menu. Press the MENU button or UP/DOWN button
repeatedly to select the mode. Press ENTER button to change the relevant topic; change the relevant topic by pressing
UP/DOWN button to set the DMX-start address or any of the pre-programmed modes or the speed values. Use the UP
button to increase the value. Use the DOWN button to decrease it. Press ENTER button again to save your settings and
get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the previously set values
MENU
ENTER
18
UP
DOWN