Delay Function; Energy Saving Function; Start / Pause / Cancel-Standby; General Operating Notes - KKT KOLBE EB8016ED Benutzerhandbuch

Programming

Delay function

!
Operating principle of the delay
The „Delayed Start" feature is set as follows:
• First, set the end time at which the dish should be ready:
for example, 18:00.
• Then the cooking time can be entered:
Example 1 hour.
• After these entries, the oven starts at 17:00.
Only when the clock has been set, the delay function can
be used. In stand-by mode:
• Press 2 times, the display shows
• Press and to set the end hour time of delay.
• Press button again.
• Press and to set the end minute time of delay.
• Press to choose the cooking function you require and
press and to enter the cooking time.
• After setting the temperature by pressing the
press to start.
Note:
After setting delay function the screen shows the
clock, and „End". Press
after 3 seconds it returns to the current working
state.

Energy saving function

• During in waiting state and reminding state , press
three seconds, the display will turn itself off and set to
energy-saving mode.
• If there's no operation in 10 minutes in waiting state, the
display will shut down and go into energy-saving mode.
• In energy-saving mode, press any key or rotate any enco-
der can quit the energy-saving mode.

Start / Pause / Cancel-Standby

• You can start working mode by pressing
• Pausing is possible by pressing the
• By pressing the -key two times, you can cancel the wor-
king mode and turn the oven to stand-by-mode.

General operating notes

• The oven light is turned on in all heating modes.
• When you have selected a heating function, but the button
be displayed or turn back to waiting state. The selected
function will be recognized as invalid.
• To make sure that your input was detected right from the
SensorTouch-Control panel, a buzzer will sound.
• When a program has finished, a buzzer will sound five
times to remind you when cooking has finished.

Meat probe (AutoCook)

and "End".
The core temperature sensor monitors the temperature
inside a dish (core). Here, a target temperature is deter-
mined. When a certain temperature has been reached in
this area, the dish is considered ready - the oven switches
off automatically.
• In waiting state, insert the meat probe, the LCD will display
„Prob" and the icon .
• Select your desired oven function with the buttons
button,
• Sequence:
• Now press
to inquire the end time,
• After that, press the buttons
temperature. Here press the button
• The small LCD display the temperature and the big LCD
display „Prob".
for
.
button.
is not pressed within 5 minutes, the current time will
and .
to confirm the setting.
and
1. The range of the temperature is between 60 and
250°C.
2. During probe function, the cooking time can not
be set.
3. To interrupt the cooking process, press the
button once. The display will flash. To cancel
the whole process, press the button
to stop the cooking process and return to the
waiting mode.
4. If you pull out the meat probe, it will also cancel
the current working.
5. If the display shows „Er-3" after the programme
has been started, this means that there's a prob-
lem with the temperature sensor.
again to adjust the
,too.
again
33