Nice neomat H Anweisungen Und Hinweise Für Den Installateur Seite 5

4.3) Optional programming
Optional programming operations can only be performed after the "0" and "1" positions have been programmed
4.3.1) Memorising the intermediate position "I"
To memorise the intermediate position proceed as follows:
Table "A4" Programming the intermediate position "I" (fig. 10)
Using keys ▲ or ▼ and ■ on a remote control, move the awning to the position that
1.
you wish to memorise as "I".
Press and hold down (approx. 5 seconds) key ■ until you hear the beep.
2.
Release and then press again key ■ for 5 more seconds until you hear 4 short beeps.
3.
Press keys ▲ and ▼ simultaneously until 3 beeps signal that the position has
4.
been memorised.
4.3.2) Programming RDC torque reduction during the closing operation
Torque reduction is a programmable function that decreases motor torque by approximately 50% just before the awning closes completely,
to prevent excessive stretching of the fabric.
Table "A5" Programming the RDC torque reduction function (fig 11)
Press and hold down key ■ on a previously memorised transmitter until you hear a beep
1.
(approx. 5 seconds).
Release and then press again key ■ for 5 more seconds until you hear 4 short beeps.
2.
Press key ■ until 3 beeps signal that the RDC function has been activated.
3.
4.3.3) Erasing the positions or the RDC function
To modify the previously memorised positions, first you need to erase them, then you must reprogram the new positions.
Table "A6" Erasing intermediate position "I" (fig. 10)
Press and hold down key ■ on a previously memorised transmitter until you hear a beep
1.
(approx. 5 seconds).
Release and then press again key ■ for 5 more seconds until you hear 4 short beeps.
2.
Press keys ▲ and ▼ simultaneously until 5 beeps signal that the intermediate position
3.
has been erased.
Table "A7" Erasing positions "0" and "1" (fig. 12)
Press and hold down key ■ on a previously memorised transmitter until you hear a beep
1.
(approx. 5 seconds).
Release and then press again key ■ for 5 more seconds until you hear 4 short beeps.
2.
Press key ▼ until 5 beeps signal that positions "0" and "1" has been erased.
3.
!
WARNING: After positions "0" and "1" have been erased, the awning will only move by manual control, therefore a
new position must be memorised.
Note: if you have programmed an intermediate position "I" and the RDC function, these will not be erased. If you wish to erase all (including
the transmitter codes) see table "A9."
Table "A8" Erasing the RDC torque reduction function (fig. 11)
Press and hold down key ■ on a previously memorised transmitter until you hear a beep
1.
(approx. 5 seconds).
Release and then press again key ■ for 5 more seconds until you hear 4 short beeps.
2.
Press key ■ until 5 beeps signal that the RDC function has been deactivated.
3.
Note: Now the awning will close at full power
GB
Example
5s
5s
Example
5s
5s
Example
5s
5s
Example
5s
5s
Example
5s
5s
5