First Start-Up - Vacon 100 series Kurzanleitung

FIRST START-UP

The Start-up wizard tells you to give necessary data for the drive to control your procedure.
1 Language selection (P6.1)
2 Daylight saving* (P5.5.5)
3 Time* (P5.5.2)
4 Year* (P5.5.4)
5 Date* (P5.5.3)
* If a battery is installed, you see these steps.
6 Run Startup wizard?
To set the parameter values manually, make the selection No and push the OK button.
7 Make a selection of an application (P1.2 Application, ID212)
Set a value for P3.1.2.2 Motor Type (so that it agrees with
8
the nameplate)
Set a value for P3.1.1.1 Motor Nominal Voltage (so that it
9
agrees with the nameplate)
Set a value for P3.1.1.2 Motor Nominal Frequency (so that
10
it agrees with the nameplate)
Set a value for P3.1.1.3 Motor Nominal Speed (so that it
11
agrees with the nameplate)
12 Set a value for P3.1.1.4 Motor Nominal Current
13 Set a value for P3.1.1.5 Motor Cos Phi
If you set Motor Type to Induction Motor, you see the next step. If your selection is PM
Motor, the value of parameter P3.1.1.5 Motor Cos Phi is set to 1.00 and the wizard goes
directly to step 14.
14 Set a value for P3.3.1.1 Minimum Frequency Reference
15 Set a value for P3.3.1.2 Maximum Frequency Reference
16 Set a value for P3.4.1.2 Acceleration Time 1
17 Set a value for P3.4.1.3 Deceleration Time 1
18 Run the Application wizard?
The selection is different
in all the language
packages
Russia
US
EU
OFF
hh:mm:ss
yyyy
dd.mm.
Yes
No
Standard
Local/Remote
Multi-step speed
PID control
Multi-purpose
Motor potentiometer
PM motor
Induction motor
Reluctance motor
Range: Varies
Range: 8.00...320.00 Hz
Range: 24...19200
Range: Varies
Range: 0.30-1.00
Range: 0.00...P3.3.1.2 Hz
Range: P3.3.1.1...320.00
Hz
Range: 0.1...300.0 s
Range: 0.1...300.0 s
Yes
No
EN
9