Section 3 - Instrument Assembly; Battery Installation/ Replacement; Interface Cables; Optional Mounting Bracket (Mb500) For Pole Mount Use - Halyard EZstim III ES500 Bedienungshandbuch

SECTION 3 – INSTRUMENT ASSEMBLY
3.A. BATTERY INSTALLATION/ REPLACEMENT
Install the 9V alkaline battery shipped with the unit as shown in
Figure 3.1 below.
Note: Use only alkaline type batteries in the ES500. Do not use
rechargeable batteries.
Figure 3.1: Battery Installation
3.B. INTERFACE CABLES
The NSL-5 cable or RBW-5U cable is plugged into the keyed jack on
the top of the unit.
Caution: Do not use cables other than those models specified
for the ES500.
Figure 3.2: Cable Connection/Disconnection
• To connect a cable, align the key on the cable connector with the
notch in the input jack and gently press the connectors together.
The user will feel a "click" when the cable locks in place.
• To disconnect a cable, grasp the black connector and pull it
straight away from the unit. Do NOT remove the cable by pulling
on the wires.
3.C. OPTIONAL MOUNTING BRACKET (MB500)
FOR POLE MOUNT USE
1. Attach mounting bracket to an IV pole.
Figure 3.3: Mounting Bracket
2. Slide the ES500 into the mounting bracket.
Figure 3.4: ES500 Docking
c
7