Manual Functions; Electronic Functions - Jacuzzi CHELSEA Projecta Installation, Bedienung, Wartung

Installation must be carried out by qualified and authorized per-
sonnel, in compliance with current national provisions.
Class "1" appliances must be immutably connected,
, to the electrical mains and the ground
system.
A multiple-pole disconnect switch must be installed for connection
to the mains. This device must ensure complete disconnection un-
der class III overcurrent conditions. The breaker must be located in a
position that respects bathroom safety regulations.
The installation of electrical devices and equipment (sockets,
switches, etc.) in the bathroom must be in compliance with legal
standards and regulations in the country where the appliance is
installed.
Connection to the electrical system of the building must be
made using a sheathed cable with characteristics not inferior to
type
.
2

MANUAL FUNCTIONS

These functions are available for all models.
-
-
-
-
equipped with simultaneous water jets that are emitted from the
nozzles on the shower column.
Jets can be tilted in four directions, by pressing the nozzle and mov-
ing it to the required position.
consists of a water jet that exits a nozzle under the seat. It is very
useful for adjusting the water temperature.

ELECTRONIC FUNCTIONS

these functions are only available for TT models.
-
-
Please see the chapter "Use of Electronic Functions".
13 13
please see