Master MASTERJUMP Benutzerhandbuch Seite 107

WARNING: READ AND FOLLOW THIS INSTRUCTION, PRIOR TO ASSEMBLE AND USE OF THIS EQUIPMENT.
3. ASSEMBLY:
STEP 1:
SPREAD THE SAFETY NET OUT FLAT ON THE TRAMPOLINE MAT FIRSTLY AS SHOWN IN FIGURE. 1,
AND PUT TWO SECTIONS OF SUPPORT PIPES CONNECTED TOGETHER AS SHOWN IN FIGURE 2.
FIGURE 1
STEP 2:
INSERT SUPPORT PIPES INTO THE SLEEVES OF SAFETY NET IN ORDER, AS SHOWN IN FIGURE 3.
STEP 3:
STAND THE SUPPORT PIPES CORRESPOND ANEAR TO EACH TRAMPOLINE LEG ORDERLY(AS
SHOWN IN FIGURE 4)t
Note that the orientation of the leg
tubes is important .The dilation
107
EN