Printer Paper; Print Paper You Can Use - Sony UP-D895 Gebrauchsanweisung

The diagram below shows the curve for each tone.
High
Low
0
Gradation
C RESIZE TO FIT
This selection is enabled when D COMMAND is
set for D890.
ON: The printed image is enlarged about 25% and
is printed as the same size as with the UP-
D890.
OFF: The printed image is not enlarged. Compared
to UP-D890 output, the printed image is about
25% smaller. (This is because pixel density
with the UP-D895 is about 25% higher than
with the UP-D890).
D COMMAND switch
Set this switch to OFF when using the UP-D895
with software applications intended for the UP-
D890.
E POSTFEED switch
Selects the paper feed method for after printing.
ON: Feeds extra blank paper between prints.
OFF: Feeds less paper between prints to conserve
paper, or when printing multiple pictures on
the same sheet. More pictures can be printed
on one sheet, but because there is so little
space between printed pictures, you must
press the FEED button before cutting the
paper.
F G H RESERVED switch
Ordinarily, leave these switches set to ON (the
factory setting).

Printer Paper

Use only Sony UPP-110S/110HD/110HG paper
designed for use with this printer. High print quality
cannot be guaranteed if any other paper is used with this
printer, and such paper could damage the printer.
Printer paper intended for use with the UP-D890
cannot be used with the UPP-110HA.

Print Paper You Can Use

255
Print paper characteristics are as follows.
Print Characteristics
TYPE I (Normal)
TYPE II (High Density)
TYPE V (High Glossy)
Storing and Handling Paper
• Stored unused paper at a temperature below 30°C
(86°F) in a dry location that is not exposed to direct
sunlight.
• Do not store unused paper near volatile liquids or
allow the paper to contact any organic volatile liquid,
cellophane tape, or any compound of vinyl chloride.
• Handle the paper carefully when loading to avoid
touching the printing surface with your fingers.
Perspiration or oil from you hands could cause
pictures to blur.
• After removing the label from the leading edge of the
paper, pull the paper out 15~20 cm (about 6~8 in.)
before printing. Label adhesive remaining on the
paper could spoil a picture.
• To prevent printed pictures from fading or changing
color, store them in a cool, dry location where the
temperature is not higher than 30°C (86°F).
• Store printed pictures in a polypropylene pouch or
between sheets of paper that contain no plastic.
• Do not store printed pictures where they will be
exposed to direct sunlight or high humidity.
• Do not store printed pictures near volatile liquids or
allow the prints to contact any organic volatile liquid,
cellophane tape, or any compound of vinyl chloride.
• To prevent fading, stack prints on or under a diazo
copy sheet.
• To mount prints on another sheet of paper, use double-
sides tape or a water base adhesive.
• Do not incinerate waste printer paper.
Paper Type
UPP-110S
UPP-110HD
UPP-110HG
7
Printer Paper