Getting Started; Part Names And Functions - Sony UP-D895 Gebrauchsanweisung

Getting Started

Part Names and
Functions
For more details, see the referenced pages numbers
enclosed in parentheses ( ).
Front
RECEIVING
ON/ OFF
Rear
USB DIP SW
OFF
ON
DIP SW FUNCTION TABLE
NO FUNCTION SW-ON
1
GAMMA
TONE
2
RESIZE TO FIT ON
3
COMMAND D895
4
5 POST FEED ON
6 RESERVED
7 RESERVED
8 RESERVED
Slide switch inside the paper tray
PAPER TYPE
4

Part Names and Functions

FEED OPEN
EMPTY
SW-OFF
TONE
AC IN
TONE
OFF
D890
OFF
S HD HG
A Power ON/OFF Switch, Power Lamp (8, 9,
10)
Switch to ON to power and light the power lamp.
B RECEIVING lamp
Lights while the printer is receiving print data from
the computer.
C EMPTY lamp (9)
Lights when the printer runs out of paper. Flashes
while the temperature control circuits are heating
the thermal head.
D FEED button (9, 11)
Hold down to feed paper. While a print job is in
progress, press to cancel the print job.
E OPEN button (8, 9, 10)
Press to open the paper door. While a print job is in
progress, press to cancel the print job.
F Paper cutter
Cuts the paper as each image is printed.
G USB connector (5)
Connects to a computer or another USB peripheral
device with a USB cable.
H DIP SW (6~7)
Select the image mode.
I Parallel connector (36-pin Amphenol) (5)
Connects to a computer or another parallel device
with a Centronics Standard interface cable.
For the ECP mode, an IEEE STD 1284 Standard
cable is required.
J AC IN connector
Connects the AC power cord provided with the
printer.
K PAPER TYPE switch
Selects the printer paper.
Select the paper type according to the type of paper
that you are going to use.
Paper Type Switch Postion
UPP-110S I (Normal)
UPP-110HD II (High Density)
UPP-110HG V (High Glossy)