Printing; Before Starting A Print Job; Starting A Print Job; Canceling A Print Job - Sony UP-D895 Gebrauchsanweisung

4
Close the paper door and press on it to shut it.
Notes
• Make sure that the paper is loaded straight. If it is
skewed, this could cause the paper to jam.
• If you did not pull out enough paper at Step 3, without
pulling on the paper press the FEED button on the
operation panel to feed some more paper out of the
printer.

Printing

Before Starting a Print Job

Always check the following points:
• Printer connected correctly? (page 5)
• DIP switches set correctly? (page 6)
• Printer driver installed? (page 6)
• Paper loaded correctly? (page 8)

Starting a Print Job

1
Press the power ON/OFF switch to turn the printer
on. The power lamp lights.
ON/ OFF
2
Confirm that the EMPTY lamp is off. If it is on,
load paper.
3
Execute the print job with the software application.

Canceling a Print Job

To cancel a print job in progress, press the OPEN button
or the FEED button.

Feeding Paper

To feed paper, press the FEED button. The printer will
continue to feed paper as long as you hold down the
FEED button. Do not attempt to pull paper out of the
printer with your hand.
FEED OPEN
RECEIVING EMPTY
EMPTY lamp
Printing
9