Assembling The Vacuum Cleaner; Using The Vacuum Cleaner - Concept beetle VP 508 series Bedienungsanleitung

EN
OPERATING INSTRUCTIONS

ASSEMBLING THE VACUUM CLEANER

NOTE:
Always disconnect the plug from the mains outlet prior to mounting or removing
accessories!
1. Connecting the flexible hose to the vacuum cleaner
Insert the flexible hose into the air suction inlet of the vacuum cleaner.
Continue pushing until you hear a clicking sound, which indicates that the correct
position has been reached. (Figure 1).
To remove the flexible hose, push the safety button and remove the hose.
The suction power can be controlled on the hose handle.
Slide controller in the closed position – stronger air flow.
Slide controller in the open position – weaker air flow.
2. Attaching the telescopic tube to the hose adapter
Place the telescopic tube on the hose adapter and turn slightly.
3. Extending the telescopic tube
Press the plastic latch and extend the smaller tube outwards.
4. Putting the floor attachment on the telescopic tube
Insert the telescopic tube into the floor nozzle and turn slightly.
The flap (Fig. 2) allows setting the floor attachment to brushing (for flat floors) or to
smooth vacuuming (for carpets).
ACCESSORIES
A. Slotted nozzle
A. Slotted nozzle
The combined slotted adapter is designed for vacuuming areas with difficult access, such as radiators, slots, corners,
The combined slotted adapter is designed for vacuuming areas with difficult access, such as radiators, slots, corners,
pedestals, spaces between upholstery, and so on.
pedestals, spaces between upholstery, and so on.
B. Upholstery nozzle
B. Nozzle with a brush
This nozzle is used to clean smaller upholstered surfaces.
This nozzle is designed for furniture, upholstery, books, lamps, and so on.
C. Nozzle for wooden fl oors
C. Upholstery nozzle
This nozzle is used to clean smaller upholstered surfaces.

USING THE VACUUM CLEANER

NOTE
Prior to using the vacuum cleaner, please make sure that the filters have been installed properly. Unwind the necessary
length of the power cord and insert the plug into the mains outlet. The ideal length of the power cord is marked by a
yellow dot on the cord. Do not unwind the power cord past the red mark!
VP5060
VP 508x
EN
(Fig. 1)
(Fig. 1)
(Fig. 2)
(Fig. 2)
35
39