Cleaning And Maintenance; Troubleshooting - Concept beetle VP 508 series Bedienungsanleitung

EN
CLEANING THE INLET FILTERS
CLEANING THE INLET FILTERS
1. Disconnect the flexible hose and remove the container.
1. Disconnect the flexible hose and remove the container.
2. Open the filter holder on the rear side of the container (Fig. 5) and remove the foam
2. Open the filter holder on the rear side of the container (Fig. 5) and remove the foam
rubber filter.
rubber filter.
3. The foam rubber filter may be cleaned mechanically by shaking them and cleaning
3. Push the button on the upper side of the HEPA filter and remove it (Fig. 6).
with a soft brush. Heavily fouled filters can be washed after this step and cleaned
4. Both the foam rubber and HEPA filters may be cleaned mechanically by shaking
with a soft brush in lukewarm water. Do not use detergents. It is important to let
them and cleaning with a soft brush. Heavily fouled filters can be washed after this
the wet parts dry thoroughly. Do not use a hair dryer for drying! Wet filters will be
step and cleaned with a soft brush in lukewarm water. Do not use detergents. It
damaged if used for vacuuming!
is important to let the wet parts dry thoroughly. Do not use a hair dryer for
4. Assemble cleaned or new components and install them in the original location
using the reverse procedure. drying! Wet filters will be damaged if used for vacuuming!
6. Assemble cleaned or new components and install them in the original location using
the reverse procedure.
Note: Wet cleaning can cause more wear and tear of the filter, and a correspondingly
shorter service life. If the vacuum cleaner does not perform with the original suction
power, the filters should be replaced with new ones.
CHECKING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid at the rear section of the vacuum cleaner (see Fig. 7).
2. Remove the filter.
3. The filter can be cleaned by tapping or shaking it. If the filter is extremely dirty, it can
be washed in lukewarm water. Let the filter dry completely before using it again.
4. Insert a cleaned or new air outlet filter, and close the air outlet grid.

CLEANING AND MAINTENANCE

The vacuum cleaner and its accessories can be cleaned with a wet cloth.
Do not immerse the power cord, plug, or appliance in water or any other liquid.
Do not use aggressive substances for cleaning, such as solvents or abrasives!

TROUBLESHOOTING

Problem
Motor out of operation
Motor has stopped
operating
VP5060
VP 508x
Cause
Plug inserted into the mains outlet
incorrectly or insufficiently.
The mains outlet is not live.
Improper or insufficient air flow. Motor
thermal protection activated.
(Obr. 5)
(Fig. 5)
(Obr. 6)
(Obr. 7)
(Fig. 6)
Solution
Check the plug connection.
Check for voltage, e.g. by connecting
another appliance.
Unplug the power cord from the
mains outlet. Check and release the air
suction and discharge holes; check the
filter cleanliness and/or replace the dust
bag. Let the vacuum cleaner cool down.
EN
41
37